Installation and set-up manual 208668 25
CRANEX Novus e 3. Installing the unit
3.9 Preparing the PC
NOTE:
The PC and any other external device(s)
connected to the system must meet the IEC 60950
standard (minimum requirements). Devices that
do not meet the IEC 60950 standard must not
be connected to the system as they may pose a
threat to operational safety.
1. Position the PC to be used with the unit at
least 1,85 m (73") away from the unit.
NOTE:
If the unit and PC are to be part of a
larger dental system or connected to local
network, make sure that all the other system
components and devices are installed,
connected and confi gured correctly. Refer to
the documentation supplied with the other
components and devices for information on
how to do this.
2. Switch the PC on and install the dental
imaging software to be used with the device.
For information on how to do this refer to the
installation/confi guration documentation
supplied with the dental imaging software.
IMPORTANT NOTE:
After the dental imaging software has been
installed a Select device window will appear.
Make sure that you select CRANEX Novus e.
NOTE:
If a disk for updating the driver is supplied with
the unit, install the driver update after you have
installed the dental imaging software.
To Next Page
Loading...
