VI Installation and set-up manual 208668
4. Checking the alignment and fi nishing the installation ............. 40
4.1 Checking the alignment of the beam and the CCD sensor .................... 40
4.2 Checking the image geometry (Ball (and Pin) Phantom test) ................ 42
4.3 Checking the positioning lights ............................................................... 44
4.4 Quality Assurance test ........................................................................... 46
4.5 Completing the Installation ..................................................................... 50
5. Aligning the unit ........................................................................... 51
5.1 Aligning the CCD sensor ........................................................................ 51
5.2 Adjusting the beam ................................................................................. 52
5.3 Adjusting the image geometry ................................................................ 54
5.4 Aligning the positioning lights ................................................................. 58
5.5 Calibrating the CCD sensor ................................................................... 61
5.6 Advanced Quality Assurance and Advanced Still Mode ......................... 63
6. The exhibition stand ..................................................................... 66
6.1 Attaching the unit to the exhibition stand ................................................ 66
To Next Page
Loading...
