User Manual
8.4: SOLO SYSTEM
MIX FEATURES > SOLO SYSTEM
8.4: MIX FEATURES > SOLO SYSTEM
SOLO
Press to solo the assigned channel
Normal button behaviour is ‘latching’ (press on - press o). Press and hold a SOLO button for momentary (non-latch-
ing) behaviour. Press and hold an active SOLO button to use the Highlight feature, which highlights a soloed channel
by attenuating other soloed channels. SOLO buttons light up orange when active.
SOLO CLR
Press to clear any active solos.
Button lights up Red to show there are active solos.
Solo Status Indicators
Indicators light to show Solo mode / status.
If only a single input channel is soloed then PFL routing will be used. If two or more input channels or any output
channel are soloed then AFL routing will be used.
SOLO (Touch Screen)
Access Solo settings menu.
Solo In Place
Switch Solo In Place (SIP) mode On or Off.
Solo In Place routes soloed signals to the main mix outputs rather than the monitor outputs, so it should not be
activated during performance. An SIP logo is shown at the top of the Touch Screen when active.
Highlight Level
The attenuation level of the unhighlighted soloed channels while Highlight is active.
With more than one active Solo, press and hold an active SOLO button to use the Highlight feature.
To Next Page
Loading...
Need help?
General
