User Manual
8.4: SOLO SYSTEM
MIX FEATURES > SOLO SYSTEM
8.4: MIX FEATURES > SOLO SYSTEM
Blend Level
The attenuation level of the primary monitor source while a PFL or AFL is active.
The default setting is -∞ (- infinity) resulting in complete mute of the normal monitor source.
Input Priority
Allow input Solos to temporarily override an output AFL.
When active, this allows convenient monitor and control of contributions to a mix. If all active solos are cleared the
system reverts to monitoring the active output AFL solos.
Solo Trim
±10dB of trim to the level of the Solo bus to the monitor system.
This control is independent of the main monitor level control.
Input Solo Mode
Set the Input Solo Mode to Auto, AFL, or PFL.
In Auto Mode the console chooses Pre-fade Listen solo (PFL) when only one Input Channel is soloed, or After-Fader
Listen (AFL) when more than one Input Channel is soloed. In AFL or PFL mode, only those solo types are used.
The PFL bus takes it’s feed from a DSP channel before the Fader and Mute button; the AFL bus takes its feed from a
DSP channel after the Fader and Panning stages.
Select Follows Solo
Enable of Disable ‘Select Follows Solo’ Mode.
When enabled, pressing a Solo button will also select that DSP channel, as if you had pressed the SEL button. It will,
for example, assign the ACS to that channel’s audio parameters. It will always choose the last DSP Channel soloed.
To Next Page
Loading...
Need help?
General
