Sourcetronic ST600 - Page 103

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-96-
16: Value 1 set through
PROFIBUS/CANopen/DeviceNet (0–1000)
17: Value 2 set through
PROFIBUS/CANopen/DeviceNet (0–1000)
18: Value 1 set through Ethernet 1 (0–1000)
19: Value 2 set through Ethernet 2 (0–1000)
20: HDIB input (0.00–50.00kHz)
21: Value 1 set through
EtherCAT/Profinet/Ethernet IP (0–1000)
22: Torque current (bipolar, 0–Triple the
motor rated current)
23: Exciting current (bipolar, 0–Triple the
motor rated current)
24: Set frequency (bipolar, 0–Max. output
frequency)
25: Ramp reference frequency (bipolar, 0–
Max. output frequency)
26: Rotational speed (bipolar, 0–Speed
corresponding to max. output frequency)
27: Value 2 set through
EtherCAT/Profinet/Ethernet IP (0–1000)
28: AO1 from the Programmable card (0–
1000)
29: AO2 from the Programmable card (0–
1000)30: Rotational speed (0–Twice the
motor rated synchronous speed)
31: Output torque (Actual value, 0–Twice the
motor rated torque)
32: AI/AO temperature detection output
33–63: Reserved
P06.17
Lower limit of AO1 output
-300.0%–P06.19
0.0%
P06.18
Corresponding AO1 output of
lower limit
0.00V–10.00V
0.00V
P06.19
Upper limit of AO1 output
P06.17–300.0%
100.0%
P06.20
Corresponding AO1 output of
upper limit
0.00V–10.00V
10.00V
P06.21
AO1 output filter time
0.000s–10.000s
0.000s
P06.22
Reserved
/
/
P06.23
PTC constant output current
setting
0.000–20.000mA
4.000 mA
P06.24
PTC resistance alarm threshold
0–60000Ω
750Ω
P06.25
PTC resistance alarm recovery
threshold
0–60000Ω
150Ω
P06.26
Actual PTC resistance
0–60000Ω
0Ω
P06.27
Lower limit of HDO output
-300.0%–P06.29
0.0%