Sourcetronic ST600 - P23-Vector Control of Motor 2

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-227-
P22.18
Rigid tapping
selection
0x00–0x31
Ones: Enable/disable
0: Disable
1: Enable
Tens: Analog port selection
0: Invalid
1: AI1
2: AI2
3: AI3
0x00
◎
P22.19
Analog filter time
of rigid tapping
0.0ms–1000.0ms
1.0ms
○
P22.20
Max. frequency of
rigid tapping
0.00–400.00Hz
50.00Hz
○
P22.21
Corresponding
frequency of
analog zero drift of
rigid tapping
0.00–10.00Hz
0.00Hz
○
P22.22–
P22.24
Reserved
/
/
/
P23––Vector control of motor 2
Function
code
Name
Description
Default
value
Modify
P23.00
Speed loop
proportional gain 1
P23.00–P23.05 fit for vector control mode only. Below
switch-over frequency 1 (P23.02), the speed loop PI
parameters are P23.00 and P23.01. Above switch-over
frequency 2 (P23.05), the speed loop PI parameters are
P23.03 and P23.04; in between them, the PI parameters
are obtained by linear variation between two groups of
parameters, as shown in the figure below.
PI parameters
Output frequency f
(P23.00,P23.01)
(P23.03,P23.04)
P23.02 P23.05
The speed loop dynamic response characteristics of
vector control can be adjusted by setting the proportional
coefficient and integral time of speed regulator. Increase
proportional gain or decrease integral time can
accelerate dynamic response of speed loop, however, if
the proportional gain is too large or integral time is too
20.0
○
P23.01
Speed loop
integral time 1
0.200s
○
P23.02
Switch over low
point frequency
5.00Hz
○
P23.03
Speed loop
proportional gain 2
20.0
○
P23.04
Speed loop
integral time 2
0.200s
○
P23.05
Switch over high
point frequency
10.00Hz
○