Sourcetronic ST600 - P92-Tension Optimization

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-249-
diameter value 2
P91.32
Tension offset
value at zero
speed
0.0–300.0%
0.0%
○
P91.33
Present roll
diameter setting
0.0–5000.0mm
0.0mm
◎
P92––Tension optimization
Function
code
Name
Description
Default
value
Modify
P92.00
Pre-drive speed
gain
0.0–100.0%
100.0%
○
P92.01
Pre-drive torque
limit
0–2
0: Set based on P03.20, P03.21
1: Set based on P93.02
2: Set based on the set tension
2
○
P92.02
Pre-drive torque
limit setting
0.0–200.0%
100.0%
○
P92.03
Zero bit
conversion
enabling
0–1
0: Disable
1: Enable
0
◎
P92.04
Initial zero bit
0.0–100.0%
10.0%
○
P92.05
Final zero bit
0.0–100.0%
50.0%
○
P92.06
Conversion time
from initial zero bit
to final zero bit
0.00–60.00s
5.00s
○
P92.07
Conversion time
from final zero bit
to initial zero bit
0.00–60.00s
5.00s
○
P92.08
Feeding interrupt
detection mode
0–3
0: Not detect
1: Detect based on digital value
2: Detect based on roll diameter calculation value
3: Detect based on feedback position
0
○
P92.09
Feeding interrupt
detection start
delay time
0.0–200.0s
20.0s
○
P92.10
Frequency lower
limit of feeding
interrupt detection
0.00–300.00Hz
10.00 Hz
○
P92.11
Error range of
feeding interrupt
detection
0.1–50.0%
10.0%
○