Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-44-
is the main interface during power-up by default. In stopped state, parameters in various states can
be displayed. Press or to shift the displayed parameter up or down.
Figure 5-4 Stopped-state parameter display 1
Press or to switch between different display styles, including list display style and progress
bar display style.
Figure 5-5 Stopped-state parameter display 2
The stopped-state parameter display list is user defined, and each state variable function code can be
added to the stopped-state parameter display list as needed. A function code which has been added
to the stopped-state parameter display list can also be deleted or shifted.
5.3.2 Displaying running-state parameters
After receiving valid running command, the VFD will enter running state, and the keypad displays
running state parameter with RUN indicator on the keypad turning on. In running state, multiple kinds
of state parameters can be displayed. Press or to shift the displayed parameter up or down.
Figure 5-6 Running-state parameter display 1
Press or to switch between different display styles, including list display style and progress
bar display style.
01: ST600
16:02:35
Forward
Local Ready
Set frequency
P17.00 Hz
50.00
DC bus voltage
P17.11 V
540.0
0x0000
AboutMonitoring
Menu
Digital input terminal state
P17.12
16:02:35
DC bus voltage
P17.11 V
540.0
Digital input terminal state
P17.12
0x0000
0x0000
Digital output terminal state
P17.13
01: ST600
Forward
Local Ready
AboutMonitoring
Menu
To Next Page
Loading...
