Sourcetronic ST600 - Editing a Parameter List

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-49-
Download motor func para
from keypad
MemArea2: BACKUP012
Upload local func para to
keypad
Download all func para from
keypad
Download NonMotor func para
from keypad
Download motor func para
from keypad
MemArea3: BACKUP03
Upload local func para to
keypad
Download all func para from
keypad
Download NonMotor func para
from keypad
Download motor func para
from keypad
Restore default (excl motor
para)
Sure to restore defaults (excl
motor para)?
Restore default (test mode)
Sure to restore default (test
mode)?
Restore default (incl motor para)
Sure to restore default (incl
motor para)?
System
settings
-
-
Language
Time/date
Backlight brightness
Backlight time
Enable power-on setup wizard
Power-on setup wizard
Keypad programming
Fault time setting
Control board programming
Up/Down key sensitivity
5.4.2 Editing a parameter list
The parameters in the parameter list in stopped state can be added as needed (through the menu of
user defined home parameters), and the list can also be edited such as "Move up", "Move down",
"Delete from the list", and "Restore default". The edit function is shown in the following.