Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-50-
Figure 5-11 List edit diagram 1
Press key to enter edit interface, select the operation needed, and press key,
key or key to confirm the edit operation and return to the previous menu (parameter list), the
returned list is the list edited. If key or key is pressed in edit interface without any
selection, it will return to the previous menu (parameter list remain unchanged).
Note: For the parameter objects in the list header, move-up operation will be invalid, and the same
principle can be applied to the parameter objects in the list footer; after deleting a certain parameter,
the parameter objects under it will be moved up automatically.
The items in the parameter list in running state can be added as needed (through the menu of user
defined home parameters), and the list can also be edited such as "Move up", "Move down", "Delete
from the list", and "Restore default parameters". The edit function is shown in the interface below.
Figure 5-12 List edit diagram 2
The parameters of user defined parameter setting can be added, deleted or adjusted as needed, such
as "Move up", "Move down", "Delete from the list", and "Restore default parameters"; the adding
function can be set in a certain function code in a function group. The edit function is shown in the
figure below.
Figure 5-13 List edit diagram 3
5.4.3 Adding parameters to the parameter list displayed in stopped/running state
You can choose Menu > State monitoring, choose a submenu, enter a specific function group and
then a specific function code to add the parameter to the list of parameters displayed in stopped state
or parameters displayed in running state.
01: ST600
16:02:35
HomepageReturn
Select
Shift up
Shift down
Delete from the list
16:02:35
Forward
Local Ready
HomepageReturn
Select
Parameter displayed in stop state
Parameter displayed in running state
01: ST600
16:02:35
EditReturn
Confirm
P17.00: Set frequency
P17.11: DC bus voltage
P17.12: Digital input terminal state
P17.13: Digital output terminal state
P17.23: PID reference value
P17.24: PID feedback value
01: ST600
Forward
Local Ready
Forward
Local Ready
01: ST600
16:02:35
Forward
Local Ready
EditReturn
Select
P00.10: Keypad setting frequency
P00.00: Speed control mode
P00.11: Acceleration time 1
P00.12: Deceleration time 1
P00.01: Running command channel
P00.13: Running direction selection
01: ST600
16:02:35
Forward
Local Ready
HomepageReturn
Select
Common parameter
setup
Parameter setup
State monitoring/fault
record
Motor parameter
autotuning
Parameter backup/restore
to default value
System setting
01: ST600
16:02:35
Forward
Local Ready
HomepageReturn
Select
Shift up
Shift down
Delete from the list
To Next Page
Loading...
