Frequency Inverter ST600 Series High-Performance Multifunction VFD Installation Guide
-19-
4.2.3 Installation mode
The VFDs can be installed in several different modes, depending on the model:
Figure 4-3 Installation modes of the standard model VFDs
For the standard models, there are three kinds of installation modes depending on the different VFD
dimensions:
• Wall-mounting: suitable for 315G3 and lower models
• Flange-mounting: suitable for 200G3 and lower models
• Floor-mounting: suitable for 220G3–500G3 models
Note:
• The flange-mounting plate is a must for standard models 1R5G3–075G3 that adopt flange-
mounting mode; while standard models 090G3–200G3 need no flange-mounting plate.
• The installation base is optional for standard models 220G3–315G3. The base can hold an input
AC reactor (or DC reactor) and an output AC reactor.
Figure 4-4 Installation modes of the SP model VFDs
To Next Page
Loading...
