Sourcetronic ST600 - Backing up Parameters; System Settings

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-54-
Figure 5-19 Selecting a parameter autotuning type
After selecting a motor autotuning type, enter motor parameter autotuning interface, and press RUN
key to start motor parameter autotuning. After autotuning is done, a message will pop up indicating
autotuning is succeeded, and then it will return to the main interface of stop. During autotuning, you
can press STOP/RST key to terminate autotuning; if any fault occur during autotuning, the keypad will
display a fault interface.
Figure 5-20 Parameter autotuning
5.4.9 Backing up parameters
You can choose Menu > Copy parameter/Restore default, and press key, key or
key to enter the function parameter backup interface and function parameter restoration interface to
upload/download VFD parameters, or restore VFD parameters to default values. The keypad has three
different storage areas for parameter backup, and each storage area can save the parameters of one
VFD, which means the keypad can save parameters of three VFDs in total.
Figure 5-21 Parameter backup
5.4.10 System settings
You can choose Menu > System settings, and press key, key or key to enter
system setting interface to set the keypad language, time/date, backlight brightness, backlight time
and restore parameters.
Note: Clock battery is not included, and the keypad time/date needs to be reset after power off. If time-
keeping after power off is needed, you should purchase the clock batteries separately.
01: ST600
16:02:35
Forward
Local Ready
AddReturn
Confirm
Ensure m otor nameplate parameters are set
correctly!
Hom epageReturn
Confirm
Com plete parameter rotary autotuning
Com plete parameter static autotuning
Partial param eter static autotuning
01: ST600
16:02:35
Forward
Local Ready
16:02:35
Com mon parameter setup
Parameter setup
State m onitoring /fault record
Motor parameter autotuning
Param eter backup/restore to default value
System setting
Forward
Local Ready
Hom epageReturn
Select
HomepageReturn
Stop
Autotuning step: 1
In parameter autotuning
01: ST600
16:02:35
Forward
Local Run
Autotuning step: 3
In parameter autotuning
01: ST600
16:02:35
Forward
Local Run
HomepageReturn
Stop
Upload local function param eters to keypad
Dow nload complete keypad function parameters
Dow nload keypad function parameters not in motor
group
Dow nload keypad function parameters in motor group
01: ST600
16:02:3 5
Forward
Local Ready
Hom epageReturn
Select
16:02:35
Common param eter setup
Parameter setup
State monitoring/fault record
Motor parameter autotuning
Parameter backup/restore to default valu e
System setting
Forward
Local Ready
HomepageReturn
Select
16:02:35
Operate the storage are a 1: BACKUP01
Operate the storage area 2: BACKUP02
Operate the sto rage area 3: BACKUP0 3
Restore function parameter to default value
Forward
Local Ready
Edit
Return
Select
01: ST600
01: ST600