Sourcetronic ST600 - Adding Parameters to the User Defined Parameter List

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-51-
Figure 5-14 Adding parameter diagram 1
After selecting a specific function code, press key to enter the parameter addition interface,
and then press key, key or key to confirm the addition operation. If this parameter
is not included in the list of parameters displayed in stopped state or parameters displayed in running
state, the parameter added will be at the end of the list; if the parameter is already in the list of
parameters displayed in stopped state or parameters displayed in running state, the addition operation
will be invalid. If key or key is pressed without any selection in the addition interface, it
will return to previous menu.
Part of the monitoring parameters in P07 HMI group can be added to the list of parameters displayed
in stopped state or parameters displayed in running state. All the parameters in P17, P18 and P19
group can be added to the list of parameters displayed in stopped state or parameters displayed in
running state.
Up to 16 monitoring parameters can be added to the list of parameters displayed in stopped state; and
up to 32 monitoring parameters can be added to the list of parameters displayed in running state.
5.4.4 Adding parameters to the user defined parameter list
You can choose Menu > Parameter groups, choose a submenu, and enter a specific function group
and then a specific function code to add the parameter to the user defined parameter list.
Figure 5-15 Adding parameter diagram 2
Press key to enter addition interface, and press key, key or key to confirm
the addition operation. If this parameter is not included in the original user defined parameter list, the
newly-added parameter will be at the end of the list; if this parameter is already in the list, the addition
operation will be invalid. If key or key is pressed without any selection, it will return to
01: ST600
16:02:35
HomepageReturn
Confirm
Add to the para m eter list d isp layed in s top state
01: ST600
16:02:35
Forw ard
Loca l Ready
AddReturn
Select
P17.00: Setting frequency
P17.01: Outp u t fre quency
P17.02: Ram ps referenc e frequ ency
P17.03: Output voltag e
P17.04: Output current
P17.05: Motor speed
Add to the para m eter list displa yed in running sta te
01: ST600
16:02:35
Sure to add to the param eter list
displayed in stop state?
Forw ard
Loca l Ready
Forw ard
Loca l Ready
HomepageReturn Confirm
01
16:02:35
01
16:02:35
P17.00:
P17.01:
P17.02:
P17.03:
P17.04:
P17.05:
Forward
Local Ready
P17.00:P17.00:
:
: ST600
HomepageReturn
Confirm
Addto the parameter list displayed in stop state
: ST600
AddReturn
Select
P17.00: Settingfrequency
Output frequency
Ramps reference frequency
Output voltage
Output current
Motor speed
Addto the parameter list displayed in running state
01: ST600
16:02:35
HomepageReturn
Confirm
Suretoaddto the parameterlist
displayed in runningstate?
Forward
Local Ready Forward
Local Ready
01: ST600
16:02:35
Forward
Local Ready
AddReturn
Select
P01.00: Runningmodeof start
P01.01: Starting frequency of direct start
P01.02: Hold-up time of starting frequency
P01.03: Brake current beforestart
P01.04: Brake time beforestart
P01.05: Acceleration/decelerationmode selection
01: ST600
16:02:35
HomepageReturn
Confirm
Sureto add to common parameter
setup?
Forward
Local Ready