Sourcetronic ST600 - P22-Spindle Positioning

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-225-
P21.32
Pulse reference
feedforward
source
0x0–0x1
0x0
◎
P21.33
Set value of
clearing encoder
count
0–65535
0
◎
P22––Spindle positioning
Function
code
Name
Description
Default
value
Modify
P22.00
Spindle positioning
mode selection
0x0000–0xFFFF
Bit0: Enable spindle positioning
0: Disable
1: Enable
Bit1: Select spindle positioning reference point
0: Z pulse input
1: S2/S3/S4 terminal input
Bit2: Search for reference point
0: Search the reference point only once
1: Search the reference point every time
Bit3: Enable reference point calibration
0: Disable
1: Enable
Bit4: Positioning mode selection 1
0: Set direction positioning
1: Near-by direction positioning
Bit5: Positioning mode selection 2
0: Forward positioning
1: Reverse positioning
Bit6: Zeroing command selection
0: Electric level mode
1: Pulse mode
Bit7: Reference point calibration mode
0: Calibrate at the first time
1: Calibrate in real time
Bit8: Action selection after zeroing signal cancellation
(electric level type)
0: Switch to speed mode
1: Position lock mode
Bit9: Positioning completion signal selection
0: Electric level signal
1: Pulse signal
Bit10: Z pulse signal source
0: Motor
1: Spindle
Bit11–15: Reserved
0x0000
○