Sourcetronic ST600 - Page 233

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-226-
P22.01
Speed of spindle
orientation
During spindle orientation, the speed of the position point
of orientation will be searched, and then it will switch over
to position control orientation.
Setting range: 0.00–100.00Hz
10.00Hz
○
P22.02
Deceleration time
of spindle
orientation
Deceleration time of spindle orientation.
Spindle orientation deceleration time means the time
needed for the VFD to decelerate from the max. output
frequency (P00.03) to 0Hz.
Setting range: 0.0–100.0s
3.0s
○
P22.03
Spindle zeroing
position 0
Users can select the zeroing positions of four spindles by
terminals (function code 46, 47).
Setting range: 0–65535
0
○
P22.04
Spindle zeroing
position 1
Setting range: 0–65535
0
○
P22.05
Spindle zeroing
position 2
Setting range: 0–65535
0
○
P22.06
Spindle zeroing
position 3
Setting range: 0–65535
0
○
P22.07
Spindle scale-
division angle 1
Users can select seven spindle scale-division values by
terminals (function code 48, 49 and 50).
Setting range: 0.00–359.99
15.00
○
P22.08
Spindle scale-
division angle 2
Setting range: 0.00–359.99
30.00
○
P22.09
Spindle scale-
division angle 3
Setting range: 0.00–359.99
45.00
○
P22.10
Spindle scale-
division angle 4
Setting range: 0.00–359.99
60.00
○
P22.11
Spindle scale-
division angle 5
Setting range: 0.00–359.99
90.00
○
P22.12
Spindle scale-
division angle 6
Setting range: 0.00–359.99
120.00
○
P22.13
Spindle scale-
division angle 7
Setting range: 0.00–359.99
180.00
○
P22.14
Spindle drive ratio
This function code sets the reduction ratio of the spindle
and the mounting shaft of the encoder.
Setting range: 0.000–30.000
1.000
○
P22.15
Zero-point
communication
setup of spindle
P22.15 sets spindle zero-point offset, if the selected
spindle zero point is P22.03, the final spindle zero point
will be the sum of P22.03 and P22.15.
Setting range: 0–39999
0
○
P22.16
Reserved
/
/
/
P22.17
Reserved
/
/
/