Sourcetronic ST600 - P13-Control Parameters of Synchronous Motor

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-197-
P13––Control parameters of synchronous motor
Function
code
Name
Description
Default
value
Modify
P13.00
Reduction rate of
the injection
current of
synchronous
motor
0.0%–100.0% rated motor current
80.0%
○
P13.01
Initial pole
detection mode
0: No detection
1: High-frequency current injection
2: Pulse superimposition
0
◎
P13.02
Pull-in current 1
Pull-in current is the pole position orientation current;
pull-in current 1 is valid within the lower limit of pull-in
current switch-over frequency threshold. If users need to
increase the starting torque, increase the value of this
function code properly.
Setting range: 0.0%–100.0% (rated motor current)
20.0%
○
P13.03
Pull-in current 2
Pull-in current is the pole position orientation current;
pull-in current 2 is valid within the upper limit of pull-in
current switch-over frequency threshold, and users do
not need to change pull-in current 2 under common
situations.
Setting range: 0.0%–100.0% (rated motor current)
10.0%
○
P13.04
Switch-over
frequency of pull-in
current
0.00Hz–200.0% (of the motor rated current)
20.0%
○
P13.05
High-frequency
superposition
frequency
200Hz–1000Hz
500
◎
P13.06
High-frequency
superposition
voltage
0.0–300.0% rated motor voltage
100.0%
◎
P13.07
Control parameter
0
0.0–400.0
0.0
○
P13.08
Control parameter
1
0x0000–0xFFFF
0x0000
○
P13.09
Frequency
threshold of
phase-lock loop
switch-in
This parameter is used to set the frequency threshold for
enabling the counter-electromotive force phase-locked
loop in SVC 0. When the running frequency is lower than
the value of this parameter, the phase-locked loop is
disabled; and when the running frequency is higher than
that, the phase-locked loop is enabled.
Setting range: 0.00–655.35
50.00
○
P13.10
Initial
0.0–359.9
0.0
○