Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-45-
Figure 5-7 Running-state parameter display 2
In running state, multiple kinds of state parameters can be displayed. The running display parameter
list is user defined, and each state variable function code can be added to the running display
parameter list as needed. A function code which has been added to the running display parameter list
can also be deleted or shifted.
5.3.3 Displaying fault information
The VFD enters fault alarm display state once fault signal is detected, and the keypad displays error
code and fault information with TRIP indicator on the keypad turning on. Fault reset operation can be
carried out via STOP/RSTkey, control terminal or communication command.
The error code will be kept displaying until fault is removed.
Figure 5-8 Fault alarm display state
5.4 Operating the VFD through the keypad
Various operations can be performed on the VFD through the keypad, including entering/exiting menu,
parameter selection, list modification and parameter addition.
5.4.1 Enter/exit menu
The keypad displays three main menus at the home interface by default: Parameter, About, and
Menu. The following figure shows how to enter the Parameter main menu and how to operate under
this main menu.
Figure 5-9 Enter/exit menu diagram 1
The following figure shows how to enter the Menu main menu and how to operate under this main
menu.
01: ST600
16:02:35
Forward
Local Ready
Set frequency
P17.00 H z
50.00
DC bus voltage
P17.11 V
540.0
0x0000
AboutMonitoring
Menu
Digital input terminal state
P17.12
16:02:35
Stop state display parameter
Running state display parameter
01: ST600
16:02:35
HomepageReturn
Select
Standard monitoring setup
01: ST600
Forward
Local Ready
HomepageReturn
Select
Forward
Local Ready
To Next Page
Loading...
