Sourcetronic ST600 - Page 114

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-107-
34
Virtual terminal output of
EtherCAT/PROFITNET/Ethernet IP
communication
The corresponding signal is output according to the
set value of PROFINET communication. When it is
set to 1, the ON signal is output, and when it is set to
0, the OFF signal is output.
35
Reserved
36
Speed/position control switch-over
completed
Output is valid when the mode switch-over is
completed
37
Any frequency reached
The frequency reached signal is output when the
present ramp reference frequency is greater than the
detection value for frequency being reached.
38–40
Reserved
41
Y1
Y1 from the programmable card
42
Y2
Y2 from the programmable card
43
HDO
HDO from the programmable card
44
RO1
RO1 from the programmable card
45
RO2
RO2 from the programmable card
46
RO3
RO3 from the programmable card
47
RO4
RO4 from the programmable card
48
EC PT100 detected OH pre-alarm
Pre-alarm of overheating (OH) detected by the
expansion card (EC) with PT100.
49
EC PT1000 detected OH pre-alarm
Pre-alarm of OH detected by the EC with PT1000.
50
AI/AO detected OH pre-alarm
Pre-alarm of OH detected by AI/AO.
51
Stopped or running at zero speed
The VFD is in stopped state or running at zero speed.
52
Disconnection detected in tension control
Disconnection is detected when the disconnection
detection is enabled in tension control.
53
Roll diameter setting reached
The set roll diameter is reached during running in
tension control.
54
Max. roll diameter reached
The max. roll diameter is reached during running in
tension control.
55
Min. roll diameter reached
The min. roll diameter is reached during running in
tension control.
56
Fire control mode enabled
The fire mode is turned on.
57–63
Reserved
/