Sourcetronic ST600 - Page 48

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-41-
Note:
1. The LCD keypad is equipped with a real-time clock, which can run properly after power off when
installed with batteries. The clock battery (type: CR2032) should be purchased by the user
separately.
2. LCD keypad has a parameter-copying function.
3. (Standard models) If you need install the keypad on another position rather than on the VFD, use
M3 screws or a keypad installation bracket for fixing, and use a keypad extension cable with a
standard RJ45 crystal head.
No.
Name
Instruction
1
State
Indicator
(1)
RUN
Running indicator;
LED off – the VFD is stopped;
LED blinking – the VFD is in parameter autotune
LED on – the VFD is running
(2)
TRIP
Fault indicator;
LED on – in fault state
LED off – in normal state
LED blinking – in pre-alarm state
(3)
QUICK/JOG
Short-cut key indicator, which displays different
state under different functions, see definition of
QUICK/JOG key for details
2
Button
area
(4)
Function key
The function of function key varies with the menu;
The function of function key is displayed in the
footer
(5)
(6)
(7)
Short-cut key
Re-definable. It is defined as JOG function by default,
namely jogging. The function of short-cut key can be
set by the ones of P07.02, as shown below.
0: No function;
1: Jogging (linkage indicator (3); logic: NO);
2: Reserved;
3: FWD/REV switch-over (linkage indicator (3);
logic: NC);
4: Clear UP/DOWN setting (linkage indicator (3)
logic: NC);
5: Coast to stop (linkage indicator (3); logic: NC);
6: Switching running command reference mode in
order (linkage indicator (3); logic: NC);
7: Reserved;
Note: After restoring to default values, the default
function of short-cut key (7) is 1.