Sourcetronic ST600 - Page 68

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-61-
Function
code
Name
Description
Default
value
P00.00
Speed control mode
0: SVC 0
1: SVC 1
2: SVPWM
3: FVC
Note: If 0, 1 or 3 is selected, it is required to
carry out motor parameter autotuning first.
2
P00.15
Motor parameter autotuning
0: No operation
1: Rotary autotuning 1; carry out comprehensive
motor parameter autotuning; rotary autotuning is
used in cases where high control precision is
required;
2: Static autotuning 1 (comprehensive
autotuning); static autotuning 1 is used in cases
where the motor cannot be disconnected from
load;
3: Static autotuning 2 (partial autotuning) ; when
current motor is motor 1, only P02.06, P02.07
and P02.08 will be autotuned; when current
motor is motor 2, only P12.06, P12.07 and
P12.08 will be autotuned.
4: Rotary autotuning 2, which is similar to rotary
autotuning 1 but is only applicable to
asynchronous motors.
5: Rotary autotuning 3 (partial autotuning),
which is only applicable to asynchronous
motors.
0
P02.00
Type of motor 1
0: Asynchronous motor
1: Synchronous motor
0
P03.00
Speed loop proportional gain
1
0–200.0
20.0
P03.01
Speed loop integral time 1
0.000–10.000s
0.200s
P03.02
Switching low point
frequency
0.00Hz–P03.05
5.00Hz
P03.03
Speed loop proportional gain
2
0–200.0
20.0
P03.04
Speed loop integral time 2
0.000–10.000s
0.200s
P03.05
Switching high point
frequency
P03.02–P00.03 (max. output frequency)
10.00Hz
P03.06
Speed loop output filter
0–8 (corresponds to 0–2
8
/10ms)
0
P03.07
Electromotion slip
compensation coefficient of
vector control
50%–200%
100%