Spektrum DX7 - Wing Type

44
45
SPEKTRUM DX7 • AIRCRAFT PROGRAMMING GUIDE SPEKTRUM DX7 • AIRCRAFT PROGRAMMING GUIDE
Wing Type
The DX7 offers three different wing types to choose from: Normal, Flaperon and Delta (also called elevon
mixing). In addition, V-Tail mixing is available from the Wing Type screen.
Normal
When the Flaperon and Delta wing functions are off, Normal wing type is selected. Use this wing type with
common aircraft that utilize only one servo for both ailerons. Normal is the default setting.
Flaperon Wing Type Selection
Flaperons require the use of one servo for each aileron and allow the use of ailerons as flaps or spoilers. This
function also allows the precise independent adjustment of up and down travel, and independent sub-trim and
differential of each aileron.
Delta Wing Type Selection
Delta wing arrangements combine the function of ailerons with the function of the elevator to allow precise
control of both roll and pitch.
[WING TYPE]
≥FLAPERON OFF
DELTA OFF
V-TAIL OFF
Press to enter
WING TYPE FUNCTION
Hold while turning on the transmitter
INCREASE and DECREASE key
To Enter the Wing Type Function
Press the DowN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP key until WING TYPE function appears on screen.
Wing Type (continued)
Flaperon Active:
[WING TYPE]
≥FLAPERON ON
V-TAIL OFF
V-Tail Active:
[WING TYPE]
FLAPERON OFF
≥V-TAIL ON
Delta Active:
[WING TYPE]
≥DELTA ON
To Select a Wing Type
Press the INCREASE or DECREASE key until the desired wing type is highlighted on screen: NORMAL,
FLAPERON, DELTA WING.
Note: When Flaperon or Delta Wing type is selected, the travel adjustment is used to adjust the
individual servo throw, while the combined aileron travel is adjusted with the aileron dual rate. It
is also possible to set aileron differential. Reverse switches are applicable for each servo. Neutral
adjustments of each servo are made by the Sub Trim Function.