Spektrum DX7 Instruction Manual

48
49
SPEKTRUM DX7 • AIRCRAFT PROGRAMMING GUIDE SPEKTRUM DX7 • AIRCRAFT PROGRAMMING GUIDE
Function Mode Flowchart
Information pertaining to each function is explained on the following pages. Functions will appear on the screen
in the same order they are shown on the flowchart below.
[REVERSING SW]
NORM
GEAR
≤
ch 1 2 3 4 5 6 7
REV.
[D/R & EXP]
POS-0
◊AILE
D/R 100%
EXP LIN
≥OUTPUT
[SUB TRIM]
≥THRO AILE
0 0
0 0
ELEV RUDD
[ELEV->FLAP MIX]
◊RATE:≥D 0%
ON
U 0%
SW:FLAP0
[TRAVEL ADJUST]
THRO
≥H 100%
L 100%
ELEV
D 100%
U 100%
AILE
L 100%
R 100%
RUDD
L 100%
R 100%
THRO
AILE
ELEV
RUDD
GEAR
FLAP
AUX2
[TIMER]
MODEL 1
DOWN-T
10:00
[DIFFERENTIAL]
FLAPERON
NORM 0%
[PROG.MIX1]
◊THRO≥ THRO ON
RATE: 0%
0%
SW:ON
OFFSET: 0
[AILE->RUDD MIX]
◊RATE: 0%
OFF
SW: MIX
[FLAP SYS.] NORM
FLAP ELEV
NORM ◊UP100% 0
0
0
MID
LAND
AUTO INH
DN100%
0%
Dual Rate & Exponential
(page 51)
Reverse Switch
(page 53)
Sub Trim
(page 54)
Travel Adjust
(page 55)
Elevator-to-Flap Mix
(page 56)
Aileron-to-Rudder Mix
(page 57)
Servo Monitor
(page 66)
Timer
(page 64)
Programmable Mixing
(1-6) (page 61)
Differential
(page 60)
Flap System
(page 58)
Function List Modes
The list mode screens display all the functions onscreen allowing the access of any function without having to
scroll through each screen. Note that there are two list modes: a System Setup List Mode that displays all the
system setup functions, and a Function List Mode that displays all the system setup functions.
To enter the Function List Mode, with the system on and in any function mode screen, press the UP and
SELECT keys simultaneously.
In list mode, pressing the UP and DowN keys will move the cursor to the desired function. Then pressing the
DowN and SELECT keys simultaneously will access the selected function.
[FUNCTION LIST]
◊DUAL RATE
º
EL≥FL MIX
º
TRAV ADJ.
º
SUB TRIM
º
REV. SW
º
EXPONENT.
º
PROG.MIX3
º
PROG.MIX2
º
PROG.MIX1
º
FLAP SYS.
º
AI≥RU MIX
INCREASE and DECREASE keyUP and DOWN key
Press to enter function List Mode
To Enter the Function List Mode
• Turn the transmitter on.
• From the main screen, press the UP and SELECT keys simultaneously.
• The system is now in Function List Mode and will display a list of all the functions available.
• Use the UP and DowN keys to Scroll through the available function.
• Press DowN and SELECT to enter a selected function.
To Exit the Function List Mode
• Press the DowN and SELECT keys simultaneously twice. The system will return to the main screen
or turn off the transmitter.

Spektrum DX7 Specifications

General

Interface	RF Wireless
Product color	Black
Remote control proper use	-
Built-in display	Yes
Maximum range	- m
Frequency band	2.4 GHz
Channels quantity	7 channels
Number of devices supported	250
Battery capacity	2000 mAh
Quantity per pack	1 pc(s)

Weight and Dimensions

Weight	- g