23
SPECIAL CASE: MULTIPLE TRIGGERS WITH SPRAY OVERLAP
Occurs if the system receives mulple start events (rising edge of trigger signal) before a spray cycle is nished. If the
me delay between two successive start events (or trigger pulses) is lower than the spray me, then there is an
overlap of two successive spray pulses.
FIXED SPRAY TIME– WITH REPEAT SPRAY
This ming mode is used to create a connuous repeon of spray period for a xed me.
Special Case: Repeat Spray, Air Overlap: If repeat o-me <= (ancipator + follower me), the air will remain on.
Note: This can happen in both xed and Variable spray mes.
Mulple Triggers with Spray Overlap
Repeat Spray
Repeat spray, air overlap
To Next Page
Loading...
