Spraying Systems AUTOJET 1750+ - Page 32

32
CREATE PMS (PREVENTATIVE MAINTENANCE) TAB
This allows for the creaon of PMs that will appear on the “Scheduler” tab aer the parameters have been created and
the “Update PM” buon has been pressed. Time frequency of the PM can be set to months or nozzle cycles.
SPARE PARTS AND SPRAY SPECIALIST TABS
A complete list of spare parts for your specic system conguraon can be found by selecng the Spare Parts tab. Parts
can be selected from the drop down list and the part descripon can be viewed or edited.
The contact informaon for your local Spraying Systems Co.
®
Spray Specialist can be found by selecng the Spray
Specialist tab. These editable boxes contain the name, phone number, and email address of your Spray Specialist.
TROUBLESHOOTING
The 1750+ provides troubleshoong ps for some of the most common issues that may occur and steps to resolve any
problems. This feature provides some troubleshoong measures you can take to try and resolve your issue before
contacng your local Spray Specialist for support.
Once the issue is selected, you will see several prompts for each issue. These prompts could suggest an acon to
preform to try and resolve the issue, a system component to check, or direct you to the system manual.
Spray Specialist Info
PM creator screen, eding the PM
PM Parts List for a Pump Repair Std
Spare Parts List