Setup ST500 Tach-Timer
© Stack Limited
44
trigger a false lap time. It is recommended that you set the Lap Masking
time to 50% of a typical lap time.
Note: It is important that you are aware that your beacon can be picked
up by other Stack users and can affect lap times if put out mid-session.
Therefore, please do not put out your beacon when cars are running. It
is also recommended that, where possible, a single beacon is shared by
all Stack runners at the circuit (although vehicles with different receiver
heights may require separate beacons). Refer to the instructions
describing the installation of the Lap Timing Sensor.
Standard feature on ST500SR. Optional on other
models.
Press and turn the rotary control to switch
between using miles per hour or kilometres per hour for the speed display.
The units that you select using this function will also determine whether
the odometer displays measurements in miles or kilometres. It will also
change the units used for the acceleration timer.
Standard feature on all models, except optional on
ST500.
Press and turn the rotary control to switch
between using millimetres or inches when you measure the
circumference of the wheel.
The units that you set for this parameter will also change the units that
To Next Page
Loading...
Need help?
General
