Setup ST500 Tach-Timer
© Stack Limited
46
Optional feature on all models.
This function works in a similar way to the
acceleration limit function described above, but
applies for deceleration. It prevents the displayed speed from
instantaneously reducing to zero if the wheel that includes the speed
sensor locks up during heavy braking, for example.
Standard on all models.
Press and turn the rotary control to adjust the
setting for wheel circumference. The Tach–
Timer uses this measurement, together with the measured wheel speed,
to calculate and display the vehicle speed and distance travelled. The
accuracy with which you measure this parameter has a direct influence
on the accuracy of these measurements.
You can set the units used for this measurement to millimetres or inches.
Standard on all models, except optional on ST500.
Press and turn the rotary control to set the
number of pulses that the wheel speed sensor
detects for each complete rotation of the wheel.
Standard on all models.
Press and turn the rotary control to adjust the
To Next Page
Loading...
Need help?
General
