TS 440 43
N Wire with terminal socket (12) must run underneath
the wiring harness (7).
N Press the wires of the wiring harness (7) into the
guides (arrows) with the aid of the wiring tool. The
black wire must run underneath the blue wire.
N Align ferrite sleeves (13, 14) as shown in the drawing.
N Coat support foot (3) with STIHL press fluid.
N Insert support foot (3) into guides of air baffle (5).
N Fit filter cover (2) and place support foot (3) in
position on tank housing.
N Insert screws (1) and tighten.
N Align plug.
N Install the electronic module, @ 14.3.
N Fit fan cover, @ 11.3.
N Fit shroud, @ 16.3
To Next Page
Loading...
