Stonex S900
+
GNSS Receiver – User Manual 16
3.5.1.3 External (Serial)
By selecting External, the only setting necessary is the external port baud rate, it must match the baud rate of
the source of the transmission. The serial port used for this datalink is the 5-pin port.
The baud rate available are:
• 9600
• 19200
• 38400
• 57600
• 115200
3.5.1.4 Bluetooth
Bluetooth has no settings. The datalink’s fully managed by the source of the transmission, for example, a
controller with Stonex Cube-a will set the datalink to Bluetooth if the “Phone network” communication mode
is selected.
To Next Page
Loading...
