STONEX S900+ - Base Network Connection Setup

Stonex S900
+
GNSS Receiver – User Manual 19
3.5.2.2 Network
S900
+
can connect to the Internet using a SIM card or a Wi-Fi connection.
Internet Settings
To use a SIM card, it must not have a PIN code, then set the SIM provider’s Access Point Name (APN).
To use a Wi-Fi connection, the SSID and the password must be set manually. SSID and password must
contain only alphanumeric characters.
Attention! Using this functionality will disable the S900
+
Wi-Fi hotspot and the IP address of the WebUI will
change. To access the WebUI the procedure is the same as shown in Chapter 3, but it’s necessary to connect
to the same Wi-Fi network set in the WebUI and use the IP address associated with the S900
+
by the
network instead of 192.168.10.1.
It’s possible to reactivate the S900
+
Wi-Fi hotspot, using Stonex Cube-a by setting Wi-Fi connect mode:
Master in Device > Wi-Fi Mode Settings.