Stonex S900
+
GNSS Receiver – User Manual 17
3.5.2 Base
As Base S900
+
can provide RTK corrections in the following formats:
• RTCM 3.2
• RTCM 3.0
• RTCM 2.3
• CMR+
• CMR
• DGPS
The PDOP threshold limits the use of the base if the PDOP value is higher.
To set the base position select Repeat Position, the coordinates requested are Longitude/Latitude/Height of
the S900
+
phase center. The phase center offset can be found on the label of one of the two battery covers,
or the Information page.
By selecting the “Single” option for the base coordinates, the S900
+
will set the phase center coordinates
calculated at the start of the base transmission.
To Next Page
Loading...
