STONEX S900+ - IMU Setup with Stonex Cube-a

Stonex S900
+
GNSS Receiver – User Manual 32
4.1 IMU with Stonex Cube-a
4.1.1 Sensor Activation and Configuration
Before using the receiver to collect points with the slanted pole, check if the pole tilt correction functionality
has been enabled. The settings to enable the Pole Tilt Correction using Stonex Cube-a, are in the Calibrate →
Sensor Options page.
On the same screen, it is possible to set the software to show on screen the tilt angle (in decimal degrees, 0° =
true vertical).