Load
Unload
Other Controls
For Manual Operations, the operator must
support the foot end of the cot.
Improper usage of the Power-LOAD system or
any accessory can cause injury to the patient or
operator. Operate the Power-LOAD system and
accessories only as described in the manuals.
MANUAL OPERATIONS
2 of 2
FFiigguurree 2266 –– MMaannuuaall ooppeerraattiioonnss
NNoottee -- If PPoowweerr--LLOOAADD will not be in use for a week or more, press the main power button to turn the product off and avoid
draining the battery. You may need to turn the product on and then off to make sure that PPoowweerr--LLOOAADD is off and not in
sleep mode.
LLooaaddiinngg PPoowweerr--LLOOAADD wwiitthh mmaannuuaall ooppeerraattiioonnss
1. Make sure that PPoowweerr--LLOOAADD is located at the head end of the vehicle patient compartment with the lifting arms down.
2. Push the cot into the vehicle patient compartment until the cot locks into PPoowweerr--LLOOAADD.
3. Make sure that the cot is locked into PPoowweerr--LLOOAADD by firmly pulling side to side on the foot end of the cot.
4. For additional loading instructions, see
Loading a cot into a vehicle manually (Power-PRO power loss)
(page 47).
UUnnllooaaddiinngg PPoowweerr--LLOOAADD wwiitthh mmaannuuaall ooppeerraattiioonnss
1. Press and hold the release lever at the foot end of the PPoowweerr--LLOOAADD system.
2. Pull to remove the cot from the vehicle patient compartment.
EN 36 6390-709-001 Rev AB.1
To Next Page
Loading...
Need help?
General
