CChheecckkiinngg tthhee bbaatttteerryy ppoowweerr lleevveell oonn tthhee PPoowweerr--LLOOAADD ccoonnttrrooll ppaanneell
WWAARRNNIINNGG
• Always return damaged batteries to a service center for recycling. Do not dispose of as unsorted municipal waste. Refer
to your local distributor for return and/or collection systems available in your country.
• Always unplug the shoreline (if applicable), disconnect the vehicle battery, press the main power button to turn the
product off, and then place the trolley into the loading position before you service PPoowweerr--LLOOAADD.
• Do not remove the battery when PPoowweerr--LLOOAADD is in operation.
To check the battery power level:
1. Make sure that the battery power LED is turned on.
2. Check the battery power level on the PPoowweerr--LLOOAADD control panel (shown as a battery symbol).
• The battery power LED is solid green when the PPoowweerr--LLOOAADD system is on and not charging.
• The battery power LED flashes green when the battery is charging.
• The error LED flashes amber when the battery is low.
CChhaarrggiinngg tthhee bbaatttteerryy
WWAARRNNIINNGG -- Do not press the main power button to turn the product off during normal use as it will prevent battery
charging.
Make sure that the battery is charged for the PPoowweerr--LLOOAADD to operate. When discharged, the battery requires a minimum
of ten hours to recharge. The batteries charge whenever the trolley is locked into the head end of the vehicle patient
compartment.
To charge the battery:
1. Raise the lifting arms and manually push the trolley into the head end of the vehicle patient compartment.
2. Lock the trolley at the head end of the vehicle patient compartment.
NNoottee -- The battery power LED flashes green when the battery is charging.
SSttoorriinngg PPoowweerr--LLOOAADD
Avoid draining the battery. All batteries lose charge during storage or periods of inactivity. If you will not use PPoowweerr--LLOOAADD
for a week or more, press the main power button to turn the product off. You may need to turn the product on and then off to
make sure that PPoowweerr--LLOOAADD is off and not in sleep mode.
SSeettttiinngg tthhee ccoott llooaadd hheeiigghhtt
You must set the cot load height for the cot with the PPoowweerr--LLOOAADD option before you place the vehicle into service. For a list
of compatible cots, see
Cot compatibility
(page 12). See the Operations Manual for your cot for more information about how
to set the appropriate cot height.
UUssiinngg aa nnoonn--uuppggrraaddeedd XX--ffrraammee ccoott ffoorr aa mmaassss ccaassuuaallttyy iinncciiddeenntt
You can use some non-compatible cots, including most X-frame cots, in a mass casualty incident.
WWAARRNNIINNGG
• Do not allow the rail clamp to overlap the red adjustment limit label on the rail tube. To prevent the rail jaws from
releasing the cot frame, the space between the rail clamp and the rail stationary jaw must never exceed 1 in. (2.5 cm).
6390-709-001 Rev AB.1 37 EN
To Next Page
Loading...
Need help?
General
