pg 10
Power Up Modes
Spillover Mode
Setting Brig to Spillover Mode allows the wet delay signal of the
currently selected preset to “spill” into bypass—or into the next loaded
preset if you’re using a Multiswitch Plus or MIDI for preset switching�
NOTE: Because of the buffer architecture, the current preset must be active
for at least 5 seconds before Spillover between presets will be operational�
Spillover is available immediately when bypassing the effect�
1 Press and hold the
FOOTSWITCH
for at least 2 seconds while powering
up Brig� Once the LED flashes RED, release the footswitch�
TIME VOICE MIX
FILTER MODREPEATS
hold (tap)
dBucket Delay
3205
multi
3005
2 Turn the MOD (SPILLOVER MODE) knob to set Spillover Mode on or
off� The LED will change color to indicate the current status as you
turn the knob�
• Spillover Mode Off: AMBER (default, minimum)
• Spillover Mode On: PURPLE (maximum)
NOTE: When Spillover is set to On, Bypass Mode is set to Buffered Bypass�
3 Press the
FOOTSWITCH
to store the Spillover Mode setting and begin
using Brig�
NOTE: The Spillover Mode setting persists across power cycles and is not
saved per preset�
To Next Page
Loading...
