Strymon BRIG - Infinite Mode Switch Setup

pg 21
External Control
Infinite Mode Switch Setup
Connect a MiniSwitch or other external momentary footswitch with a
TRS cable to provide infinite delay repeats on demand, whenever the
switch is held�
NOTE: Your Strymon MiniSwitch’s internal jumper switch must be changed
from the factory-default FAV/BOOST Mode to the TAP Mode setting for
Infinite Mode Switch functionality—see page 19�
1 Configure the EXP/MIDI jack for Infinite Mode� (See page 13 or
more info�)
2 Connect an external switch with a TRS cable to the EXP/MIDI jack�
OR
3 To Engage Infinite Mode: Press and hold MiniSwitch to engage infinite
repeats� Release the external footswitch to disengage Infinite mode�