pg 12
LED Brightness
You can adjust the brightness of Brig’s LED to optimize visibility in any
environment or lighting conditions�
1 Press and hold the
FOOTSWITCH
for at least 2 seconds while powering
up Brig� Once the LED flashes RED, release the footswitch�
TIME VOICE MIX
FILTER MODREPEATS
hold (tap)
dBucket Delay
3205
multi
3005
2 Press and hold the
FOOTSWITCH
again and turn the MOD (LED
BRIGHTNESS) knob to adjust the brightness of the LED from low to
high (the default)� Release the
FOOTSWITCH
when your adjustment
is complete�
3 Press and release the
FOOTSWITCH
to store the LED Brightness
setting and begin using Brig�
NOTE: The LED Brightness setting persists across power cycles and is not
saved per preset�
To Next Page
Loading...
