pg 16
External Control
Expression Pedal Setup
Use a TRS expression pedal to remotely control the knobs of Brig� By
default, Brig is configured so that an Expression pedal controls the MIX
knob�
1 Configure the EXP/MIDI jack for Expression Mode� (See page 13 for
configuration instructions�)
2 Connect an expression pedal to the EXP/MIDI jack of Brig using a TRS
cable�
RIGHT IN LEFT OUT RIGHT OUT EXP
MIDI IN
USB
MIDI OUT
3 Press and hold the FOOTSWITCH for at least 3 seconds, until the
LED blinks GREEN�
4 Rock your expression pedal to the HEEL position� The GREEN LED
will stop blinking and remain lit�
5 Set the knob(s) you would like to control to the desired settings for the
HEEL position of the expression pedal�
6 Rock the expression pedal to the TOE position� The LED will turn RED�
7 Set the knob(s) you would like to control to the desired settings for the
TOE position of the expression pedal�
8 Press and release the Brig
FOOTSWITCH
to exit and store your
expression pedal setup�
NOTE: Your expression pedal assignment is saved per Favorite setting or
MIDI preset�
NOTE: If Brig is set to respond to MIDI EXPRESSION and the EXP/MIDI jack is
set to MIDI Mode, you can send MIDI CC# 100 with values 0 (heel) to 127 (toe)
to perform the expression pedal setup�
To Next Page
Loading...
