pg 32
MIDI Specifications
MIDI Program Changes
Your Brig pedal contains 300 preset locations, numbered sequentially
from 0-299� Because MIDI Program Change messages have a maximum
number of 128 (0-127), the presets are grouped into three MIDI patch
banks�
MIDI BANK PRESETS
MIDI BANK 0 = PRESETS 0-127
MIDI BANK 1 = PRESETS 128-255
MIDI BANK 2 = PRESETS 256-299
MIDI PROGRAM CHANGE ACCESSED BY
MIDI PROGRAM
CHANGE 0
Favorite setting (accessible via MiniSwitch)
See page 17 for details�
MIDI PROGRAM
CHANGE 1
MultiSwitch Plus - footswitch 1
MIDI PROGRAM
CHANGE 2
MultiSwitch Plus - footswitch 2
MIDI PROGRAM
CHANGE 3
MultiSwitch Plus - footswitch 3
MIDI PROGRAM
CHANGE 127
Manual Mode (“knobs”)
NOTE: Some MIDI applications and controllers start with MIDI Program
Change 1 instead of 0� In these setups, increment the MIDI Program Change
locations above by one�
The Brig pedal always powers up in MIDI Patch Bank 0, so if you plan to
stay within the first 127 presets, simply send a standard MIDI Program
Change message to load a preset�
If you will be using MIDI Banks 1 and/or 2, it is advisable to send a
standard MIDI Bank Change message (MIDI CC# 0 with a value equal to
the MIDI Bank#) before each MIDI Program Change�
Selecting Program Change 127 within any MIDI Bank 0, 1, or 2 will put
Brig into Manual Mode� In this mode, Brig will be set to the current knob
and switch settings� No preset data can be stored at this preset location�
To Next Page
Loading...
