Strymon BRIG - Setting MIDI Out Mode

pg 30
Configuring Brig to Use MIDI (continued)
STEP 3  SET MIDI OUT MODE
1 Press and hold the footswitch for at least 2 seconds while powering
up Brig� Once the LED flashes RED, release the footswitch�
TIME VOICE MIX
FILTER MODREPEATS
hold (tap)
dBucket Delay
3205
multi
3005
2 Turn the FILTER (MIDI OUT) knob to select what kind of MIDI data is
sent from Brig to other MIDI devices� The LED will flash momentarily
to indicate your selection�
• OFF: RED (default, minimum) - No MIDI messages are sent out of
Brig�
• THRU: BLUE (11 o’clock) - Incoming MIDI messages are sent to the
MIDI Out without any additional MIDI messages generated by Brig�
• SEND CC, OTHER: GREEN (1 o’clock) - MIDI CC and Sysex
messages generated by Brig are sent to the MIDI Out�
• SEND OTHER: AMBER (maximum) - Sysex messages generated
by Brig are sent to the MIDI Out�
3 Press the FOOTSWITCH to store the MIDI Out Mode and exit�
NOTE: MIDI data is sent from the RING of the TRS connection of the EXP/
MIDI jack�