Strymon BRIG - Page 41

pg 41
Power Up Modes - Quick Reference
Global parameters and functions can be accessed via a power up
procedure� All power up functions persist through power cycles�
1 Press and hold theBrig FOOTSWITCH for at least 2 seconds while
powering up Brig� Once the LED flashes RED, release the FOOTSWITCH�
2 Adjust the desired functions with the controls noted below�
3 Press the FOOTSWITCH to store your changes and exit Power Up Mode�
POWER UP MODE OPTIONS
BYPASS MODE
FOR MONO I/O
See page 9
for an illustrated
description�
Set the VOICE switch - status shown on the LED
• True Bypass: switch in the 3205 (left) or 3005
(middle) position - LED GREEN (default)
• Buffered Bypass: switch in the multi (right) position
- LED RED
SPILLOVER MODE
See page 10
for an illustrated
description�
Turn the MOD knob - status shown momentarily on the
LED
• Off: AMBER (default, minimum knob position)
• ON: PURPLE (maximum knob position)
DRY SIGNAL
See page 11
for an illustrated
description�
Turn the REPEATS knob - status shown momentarily on
the LED
• Digital: GREEN (default, minimum knob position)
• Analog: RED (12 o’clock knob position)
• Kill Dry: BLUE (maximum knob position)
LED BRIGHTNESS
See page 12
for an illustrated
description�
Press and hold the footswitch again and turn the MOD
knob to adjust the brightness of the LED�
EXP/MIDI JACK
MODE
See page 13
for an illustrated
description�
Turn the MIX knob - status shown on the LED
• Expression: GREEN (default, minimum knob position)*
• Favorite: AMBER (11 o’clock knob position)
• Tap: RED (12 o’clock knob position)
• Infinite: PURPLE (2 o’clock knob position)
• MIDI: BLUE (maximum knob position, also for using
MultiSwitch Plus)
*NOTE: Also see “Expression Pedal Setup” on page 16 to configure your
pedal functionality per preset�