pg 15
Deco - tape saturation & doubletracker
Live Edit Functions
MIDI Clock Sync
Selects whether Deco’s echo repeats will sync to incoming MIDI Clock
messages�
1 Press and hold the TAPE SATURATION ON footswitch� Once both
LEDs flash, release the footswitch�
2 Set the position of the TYPE (MIDI CLOCK SYNC) switch to select
whether Deco will sync to incoming MIDI Clock messages� Both LEDs
will momentarily change color to indicate the current status as you
set the switch�
• Set the switch down to bounce for Off (default): both LEDs light
RED - Deco will not respond to MIDI Clock�
• Set the switch up to sum for On: both LEDs light BLUE - Deco will
respond to MIDI Clock�
NOTE: When synced to MIDI Clock, the DOUBLETRACKER ON LED will light
PINK, and the LAG TIME knob will act as a multiplier or divider of the incom-
ing clock tempo� The synced LAG TIME mult/div settings from left to right
are: x1, x2, x3, x4, x6, and x8� Maximum delay time is 500ms�
3 Press either footswitch to exit and store your MIDI Clock setting�
NOTE: The MIDI Clock setting is saved per Favorite setting or MIDI preset�
To Next Page
Loading...
