Strymon DECO - General Options Setup

pg 42
Deco - tape saturation & doubletracker
Power Up Modes Quick Reference
Global parameters and functions can be accessed via a power up proce-
dure� All power up functions persist through power cycles�
General Options
1 Press and hold the DOUBLETRACKER ON footswitch while power-
ing up Deco� Once both LEDs flash, release the footswitch�
2 Adjust the desired functions with the knobs and buttons noted below�
3 Press either footswitch to store your changes and exit power up mode�
INPUT MODE
See page 17
for an illustrated
description�
Turn SATURATION knob - status shown on both LEDs
• Normal: GREEN (default)
• Studio: RED
BYPASS MODE
See page 18
for an illustrated
description�
Turn LAG TIME knob - status shown on DOUBLETRACKER
ON LED
• True Bypass: GREEN (default)
• Buffered Bypass: RED
FACTORY RESET
See page 35
for an illustrated
description�
Turn VOLUME knob from 0% to 100% and back two times -
status shown on both LEDs