pg 32
Deco - tape saturation & doubletracker
MIDI Functionality (cont.)
Saving Presets in MIDI Mode
When in MIDI mode, the currently loaded settings can be saved to any of
Deco’s 300 preset locations at any time�
1 To enter Save mode, press and hold BOTH footswitches� Both LEDs
will blink GREEN to indicate that Deco is waiting to receive a MIDI
Program Change message�
2 To save the current state of the pedal to the currently loaded preset
location, press and hold the TAPE SATURATION ON footswitch until
the LED lights BLUE�
OR
To save the current state of the pedal to any preset location, send
the unit a MIDI Program Change on Deco’s currently selected MIDI
channel� For example:
• Send MIDI Program Change #10 to save the preset to the corre-
sponding memory location on the pedal�
• To recall this preset, send MIDI Program Change #10 from your
MIDI controller or sequencer�
NOTE: Press the DOUBLETRACKER ON footswitch to cancel the save operation�
To Next Page
Loading...
