pg 25
Deco - tape saturation & doubletracker
External Control
Configuring MultiSwitch Plus
Configure Deco and MultiSwitch Plus for remote access to three
additional presets�
1 Press and hold the TAPE SATURATION ON footswitch while connect-
ing power to the pedal� Hold until both LEDs stop blinking�
2 Turn the SATURATION knob all the way counter-clockwise to set the
MIDI channel to Channel 1� The DOUBLETRACKER ON LED should be
GREEN�
3 Turn the TONE knob to select any of the following MIDI OUT options�
Both ON LEDs light to indicate your selection:
• Send MIDI CC, PC, and Other Data: WHITE
• Send MIDI CC and Other Data: GREEN
• Send MIDI PC and Other Data: PURPLE
• Send Other Data: AMBER
4 Turn the LAG TIME knob all the way clockwise to set the EXP/MIDI
jack to MIDI mode� The DOUBLETRACKER ON LED should be BLUE�
5 Press either footswitch to exit and store the MIDI channel, the MIDI
OUT setting, and the EXP/MIDI jack mode�
6 Connect a TRS cable to the EXP/MIDI jack on Deco�
7 Press and hold the A footswitch on MultiSwitch Plus while connecting
the other end of the TRS cable to any one of the three jacks to set it to
Preset mode�
To Next Page
Loading...
