pg 35
Deco - tape saturation & doubletracker
Factory Reset
Performing a Factory Reset restores the pedal to its factory default
Power-up modes and secondary functions, and replaces all stored pre-
sets with their factory default settings�
1 Press and hold the DOUBLETRACKER ON footswitch while connect-
ing power to the pedal� Once both LEDs flash, release the footswitch�
2 Sweep the VOLUME knob from 0-100% and back two times� Both
LEDs will change colors at the extremes of the knob range and blink
RED to indicate when the reset is taking place�
• TURN 1: AMBER
• TURN 2: RED
• TURN 3: AMBER
• TURN 4: Both LEDs flash RED, Deco resets and restarts
To Next Page
Loading...
