pg 18
Deco - tape saturation & doubletracker
Power Up Modes
Bypass Mode
Setting Deco to Buffered Bypass mode preserves the high frequency
response of your instrument’s signal through your pedal chain and
long cable runs�
1 Press and hold the DOUBLETRACKER ON footswitch while power-
ing up Deco� Once both LEDs flash, release the footswitch�
2 Turn the LAG TIME (BYPASS MODE) knob to choose between True
Bypass or Buffered Bypass modes� The DOUBLETRACKER ON LED
will change color to indicate the current status as you turn the knob�
• True Bypass: GREEN (default)�
• Buffered Bypass: RED
3 Press either footswitch to store the Bypass Mode and begin using
Deco�
NOTE: The Bypass Mode setting persists across power cycles and is not
saved per preset�
To Next Page
Loading...
