pg 33
Deco - tape saturation & doubletracker
MIDI Specifications
MIDI Program Changes
Deco contains 300 preset locations, numbered sequentially from 0-299�
Because MIDI Program Change messages have a maximum number of
128 (0-127), the presets are grouped into three MIDI patch banks�
MIDI BANK 0 = PRESETS 0-127
MIDI BANK 1 = PRESETS 128-255
MIDI BANK 2 = PRESETS 256-299
0 Favorite setting (accessible via MiniSwitch)
See page 22 for details�
1 MultiSwitch Plus - footswitch 1
2 MultiSwitch Plus - footswitch 2
3 MultiSwitch Plus - footswitch 3
127 Manual mode (“knobs”)
NOTE: Some MIDI applications and controllers start with MIDI Program
Change 1 instead of 0� In these setups, increment the MIDI Program Change
locations above by one�
Deco always powers up in MIDI Patch Bank 0, so if you plan to stay within
the first 127 presets, simply send a standard MIDI Program Change
message to load a preset�
If you will be using MIDI Banks 1 and/or 2, you must send a standard
MIDI Bank Change message (MIDI CC# 0 with a value equal to the MIDI
Bank#) before each MIDI Program Change�
Selecting bank 0, patch 127 will put Deco into Manual mode� In this
mode, the pedal will be set to the current knob and switch settings� No
preset data can be stored at this preset location�
To Next Page
Loading...
