pg 38
Deco - tape saturation & doubletracker
Specifications
Input Impedance: 1 Meg Ohm
Output Impedance: 100 Ohm
A/D & D/A: 24-bit 96 kHz
Max Input Level +10 dBu
Signal/Noise 109 dB typical
Bypass Switching True Bypass (electromechanical relay switching)
Dimensions 4�5” deep x 4” wide x 1�75” tall
Power Adapter Requirements
Use an adapter with the following rating: 9VDC, center negative, 300mA
minimum�
© 2022 Damage Control Engineering, LLC�
Strymon, the Strymon logo, and Damage Control Engineering are trademarks or registered
trademarks of Damage Control Engineering, LLC� in the U�S� and/or other jurisdictions�
To Next Page
Loading...
