pg 17
Deco - tape saturation & doubletracker
Power Up Modes
Input Mode
Deco provides two input modes to tailor the range of the Tape
Saturation for your input signal�
1 Press and hold the DOUBLETRACKER ON footswitch while power-
ing up Deco� Once both LEDs flash, release the footswitch�
2 Turn the SATURATION (INPUT MODE) knob to select the Input Mode�
Both ON LEDs will change color to indicate the current status as you
turn the knob�
• Normal: GREEN (default) -
Input headroom is set for an instrument
level source, such as a guitar or a bass� Normal mode is recom-
mended when using Deco on your pedalboard in front of an amp�
• Studio: RED - Tailors the Saturation range to be best suited for
hotter input signals� Studio Mode is recommended when using
Deco with DAWs, mixer inserts, line level synths, or hot effects
loops in guitar rigs� 10dB of headroom is added�
3 Press either footswitch to store the Input Mode and begin using
Deco�
NOTE: The Input Mode setting persists across power cycles and is not saved
per preset�
To Next Page
Loading...
