38 INSTALLATION
4.1 RECEIVING
Every Sullivan-Palatek
testing ensures that the air compressor is functioning properly and will deliver its rated pressure and
4.2 MOVING AND LIFTING
WARNING! Keep personnel out from under and away from the area when moving or liing the compressor.
CAUTION!
4.3 LOCATION AND SUPPORT
Install the compressor on a level, hard surface capable of supporting its weight in a clean, well-lit and
When installing on a mezzanine, ensure there is proper beam and brace support for the compressor’s weight
NOTE! Refer to Technical Data on page 6 for the compressor’s dimensions, weight and other specs that must be
accommodated.
4.4 INTAKE AIR
following guidelines:
»
»
»
»
»
4.5 VENTILATION AND COOLING
The location where the compressor is installed must have adequate ventilation to maintain the rated
CAUTION! Do not install a compressor without adequate freeze protection where it will be exposed to
NOTE! Heat rejection is the amount of heat radiated by the compressor. Fan air ow is the required volume of air
per unit time which must ow through the compressor for proper ventilation.
To Next Page
Loading...
